The Antminer Z15 is the newest ASIC model by Bitmain for Equihash mining. (Antminer Z15 is 3x more powerful and efficient than the Bitmain Antminer Z11) All crypto coins based on the Equihash algorithm are supported including Zcash. It hits a hashrate of 420k Sol/s with a power consumption of 1510w for Equihash mining which is about three times, the hashrate of the older Antminer Z11 ASIC and with just a bit higher power usage.
Antminer Z15 420 Ksol/s is one of the best Zcash miners, it was released in June 2020.
|Energy efficiency ratio(25 ℃ environment,J/TH)|
|Network connecting Type||RJ45 Ethernet 10/100M|
|Gross weight(1 carton)|
The flat cable and fan interface on control board are directly connected to IC pins. If these interfaces are touched without releasing the carried ESD, the IC pins are easily damaged to cause failure of the miner which can only be returned to the manufacturer for repairment.
Power Off before Maintenance
Power off the miner before miner installation or maintenance, otherwise the hashboard or control board will be damaged and can only be returned to the manufacturer for repairment.
Power on hashboard first, then control board. If one power supply for one miner, power on directly after the hashboard and control board have been connected.
Direction of 6PIN Interface
Pay attention to the direction of 6PIN cable before connection, otherwise the power protection may be triggered, control board or hashboard may be damaged.
It’s recommended to connect one power supply to one miner.
One miner can be connected to one or multiple power supplies, but multiple miners shall not be connected to multiple power supplies.
One hashboard can only be driven by one power supply. It’s prohibited to provide multiple power supplies for one hashboard.
Leave your message and we will contact you within 24 hours