|Model||AvalonMiner A1166 Pro|
|Power supply||3400W (+/-5%)|
|Network connecting Type||RJ45 Ethernet 10/100M|
|Gross weight(1 carton)||14.1kg|
When the air duct before the heat sink of the miner is blocked, the miner’s working performance will be affected. It’s easy to trigger temperature protection and halt the miner. In other words, don’t allow too much dust accumulated on the heat sink of the miner. In spring, catkins are easy to accumulate to block the air inlet, be sure to install dust mesh on the windows of the mining farm.
When water curtain is used, the large amount of accumulated dust will absorb the moisture to corrode the hashboard, in some serious cases, the hashboard might be completed damaged. It’s recommended to keep the humidity below 65%. Due to large salt content in the air in coastal regions, the hashboard will be easily corroded by heavy dust accumulation.
If the network problem can be solved within 15 minutes, no need to power off the miners. If the network problem cannot be solved within short time, please power off the miners in time, especially when the network connection is unstable, miner crash or other failures may occur.
Please consult the router manufacturer for the router load. It’s recommended to make it clear before miner procurement.
Low Temperature Environment
When the indoor temperature of mining farm is lower than 5°C, hash speed may decrease or the miners are under performance.
Miners running in high temperature for a long time are easy to be damaged. It is recommended to maintain the environment temperature between 5°C to 35°C.
Antminers can be connected to LAN through cables only, WIFI is not supported (Except Antminer S1).
Specifications of Network Cable
Conventional RJ45 cable in any specifications
Sequence of Power Wiring
No sequence requirement on the 6pin cable connecting miner and power supply, if only no reverse or pseudo connection.
What’s the voltage for the miner?
The input of miner is 12V DC, which needs to be converted by power supply.
The power supply for miner is usually single-phase 220V (Bitmain Antminer Power supply 200-240 Volt. Whatsminer Power supply 200-277 Volt)
Do not connect the switch or router with POE function directly to miners, otherwise the control board may be damaged. It won’t be a concern for home mining.
Be sure to take lightning protection, otherwise, all equipment will be damaged. It won’t be a concern for home mining.
Leave your message and we will contact you within 24 hours